Banjo · 5 STRINGS

Banjo Standard G Tuning

The reference tuning for the banjo: G D G B D, low to high.

How to tune

Getting into Standard G

Work down the list in order — each string's tension moves the ones already set.

  1. Allow microphone access

    Asked once. Detection runs on your device; nothing is uploaded.

  2. Play one string at a time

    Let it ring open. A strummed chord gives the detector several pitches.

  3. Centre the needle

    Sharp means loosen, flat means tighten. Inside three cents is in tune.

  4. Work up from string 5, one at a time

    The lowest string carries the most tension, so setting it first means the rest hold. The panel below lists every target in that order.

  5. Run through every string once more

    Setting one string drifts the rest; the second pass makes it hold.

Strings

Every string at standard pitch

This is the reference every other banjo tuning is measured against.

Standard G
1String 1 stays at D4, 293.66 hertz.D4
2String 2 stays at B3, 246.94 hertz.B3
3String 3 stays at G3, 196.00 hertz.G3
4String 4 stays at D3, 146.83 hertz.D3
5String 5 stays at G4, 392.00 hertz.G4

Select a string in Note Locking above to hold the tuner on it while you turn the peg.

About this tuning

About Standard G Tuning

Banjo Standard G tuning sets the 5 strings to G4 D3 G3 B3 D4, listed from the lowest-pitched string up.

This is the standard reference tuning for the banjo, so every other tuning on this site is described relative to it.

Also known as

  • GDGBD tuning

Note frequencies

Standard G string frequencies

The 5 open strings of Banjo Standard G, lowest first, at A4 = 440 Hz. Each one is the pitch the tuner is listening for — G4 is G in octave 4.

NoteAlsoSolfègeFrequency
G4Sol392.00 Hz
D3Re146.83 Hz
G3Sol196.00 Hz
B3Si246.94 Hz
D4Re293.66 Hz

Sharps and flats share a pitch on a tuner: C♯ and D♭ are the same frequency, and which name you use depends on the key you are in, not on what the meter reads.

Questions

Standard G tuning, answered

The reference tuning for the banjo: G D G B D, low to high. The 5 strings are tuned G4 D3 G3 B3 D4, from the lowest-pitched string up.

Yes. The tuner on this page listens through your device microphone and compares what it hears against the exact frequencies for G4 D3 G3 B3 D4. Play one string at a time in a quiet room, and let the note ring rather than strumming.

No. This Standard G tuner runs in your browser — there is nothing to download, nothing to install and no account to create. Allow microphone access when the browser asks and the tuner starts listening. It works the same way on a phone, a tablet and a desktop.

Related tunings

Each one is described as the move from Standard G, so you can see how far away it is before you commit to turning a peg.

TrueTuner

© 2026 Artac. All rights reserved.